22270 Autoloader 2 ALE2: Pressure sensors need calibrating Trendsetter_VLF_Auto The picker pressure sensor and main pressure sensor do not give the same reading. Error and operator prompt generated if either main of picer cal is zero or more than 2000, or picker sensor differs from main sensor by more than 1.0 psi. Check air supply, use command cal pressure flow on|off and check the pre-regulator guage is at least 90 psi with flow on. Obtain Fluke 713-100G pressure calibrator 90-1188a and/ or precision Pressure calibration transducer 90-1189a, and follow procedure for calibrating pressure sensors . Check that air pressure is above 90 psi. The picker pressure sensor and main pressure sensor do not give the same reading. ../commands/cal_pressure.xmlCommand: cal pressure ../nvs/al_cfg_aoff.xmlNVS: al aoff ../nvs/al_cfg_ppsc.xmlNVS: al ppsc ../nvs/al_cfg_mpsc.xmlNVS: al mpsc ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:34:02 2008 PST